CENTRO - NITRO ENGINE WARMER C2500

CENTRO - NITRO ENGINE WARMER C2500

The Centro Engine Warmer uses technology similar to that used by Formula 1, Indy Car and NASCAR teams! It will properly pre-heat your engine to 60-70C in 10 minutes based on an ambient temperature.

The engine warmer will pre-heat all the critical parts of your nitro engine, giving you minimal of stress and wear on the engine. It helps to relieve the stress on the crank, con-rod, piston and sleeve during warm up. It also gives you a very easy and smooth engine start, with no stress on your starterbox. Fuel consumption is much less as you do not have to spend time warming up and adjusting your engine.

A pre-heated glow plug will increase the life of your plug. It is also perfect for break-in, as it reduces the ‘pinch’ on your new engine.

This useful warmer will quickly pay for itself by increasing engine life and performance.

Centrp Engine Warmer Features :
● MCU control heating time and heating power for maximum safety
● Safety timer: turn off power around 10 minutes automatically
● Built-in temperature sensor to control the output power of the heater
● LED indicator for status of engine heater
● 12V DC source with low voltage cutoff
● Fireprrof and heat resistant adjustable cover
● Fits all .19-.26 RC nitro engines
● Very small, lightweight and compact for quick and easy storage
● Access port on top allows you to start and monitor your engines temperature without having to take the heater off.

Spec Check :
● Input Voltage: 12V DC
● Heating Power: 90W
● Heating Time: Around 10 mins
● Low Voltage Cutoff: 9-10V
● Weight:65g
● Diameter: 63mm
● Height: 50mm